Rain is-pouring down on you. Your friend asks where so much water
came from. You explain that the water could once have been
a) in a lake.
c) in an ocean.
-b) in-a river.
d) any of the above.

Answer:

The strongest intermolecular force in sulfur dioxide is dipole-dipole forces.

Explanation:

The interparticle force in [tex]SO_{2}[/tex] (sulfur dioxide) is the dipole-dipole interaction.

Dipole-dipole interaction is a type of intermolecular force that occurs between polar molecules. Polar molecules have a permanent dipole moment, which means they have a partial positive charge on one end and a partial negative charge on the other end. This creates an electrostatic attraction between the partial charges of neighboring molecules. The stronger the dipole moment of a molecule, the stronger its dipole-dipole interaction will be with other polar molecules.

Dipole-dipole interactions are responsible for a variety of physical properties of substances, including their boiling and melting points. Substances with strong dipole-dipole interactions tend to have higher boiling and melting points than substances with weaker interactions. In addition, the strength of dipole-dipole interactions can affect solubility, as polar substances tend to dissolve better in other polar substances due to their ability to form dipole-dipole interactions.

Learn more about dipole-dipole interaction, here:

https://brainly.com/question/30510859

#SPJ2

Answer:

the force that you applied caused the notebook to move.the force applied on the notebook by the table causes it to stop moving. this is because after sometime the book uses up the force and later the force you applied is less than that of the force by the table.

Answer:

vigorous

Explanation:

As you go down group one of the periodic table, the reactions become and more vigorous.

This question is providing the masses of carbon dioxide and oxygen gases at 10.0 atm as 66 g and 16 g respectively, and is asking for the partial pressure of the former which turns out to be 7.50 atm after doing the math.

Thus, we can start solving this problem with the Dalton's law approach, in order to make a relationship for the total pressure, partial pressure and mole fraction, which means we must first determine the mole fraction of carbon dioxide gas in the mixture as shown below:

[tex]x_{CO_2}=\frac{n_{CO_2}}{n_{CO_2}+n_{O_2}}[/tex]

Next, we calculate the moles of both gases by dividing the grams over the molar masses:

[tex]n_{CO_2}=\frac{66g}{44.01g/mol} =1.50mol\\\\n_{O_2}=\frac{16g}{32g/mol} =0.5mol[/tex]

Then, the mole fraction of carbon dioxide as the required one by plugging in the previously calculated moles:

[tex]x_{CO_2}=\frac{1.5}{1.5+0.5}=0.75[/tex]

Finally, we use the definition of the Dalton's law to calculate the partial pressure of carbon dioxide gas in the binary mixture:

[tex]P_{CO_2}=x_{CO_2}P\\\\P_{CO_2}=0.75*10.0atm\\\\P_{CO_2}=7.50 atm[/tex]

Learn more:

(Dalton's law) https://brainly.com/question/14119417

Answer: Global warming causes sea-level rise as oceans expand, and makes storm patterns more energetic. Consequently it will affect most of the world's coastlines through inundation and increased erosion.

Explanation:

To solve such this we must know the concept of acid and base reaction. Therefore, the concentration of acid decides the concentration of hydrogen gas evolved.

Chemical reaction is a process in which two or more than two molecules collide in right orientation and energy to form a new chemical compound. The mass of the overall reaction should be conserved. There are so many types of chemical reaction reaction like combination reaction, double displacement reaction.

When creating mixture the amount of hydrogen gas is directly related to the concentration of the acid mixture, the higher the concentration level The more hydrogen gas would be produced.

Therefore, the concentration of acid decides the concentration of hydrogen gas evolved.

Learn more about the chemical reactions, here:

https://brainly.com/question/3461108

#SPJ2

Answer:

5. 0.02 seconds

6. (a) 0.0167 seconds

(b) Period in Lebanon is 0.02 seconds and in the U.S 0.0167 seconds. That means that the U.S. has the faster period.

Explanation:

find the distance between

the following points:

a) AC0₂0) and B(5, 2)

Answer: Cell wall

Explanation: Cell wall is a unique structure found only in some specific organisms like plants, bacteria, fungi etc. The cell wall in plants is predominantly made up of a polysaccharide called CELLULOSE. This carbohydrate confers upon the cell "rigidity".

The cell wall is an additive material including the cell membrane that coats the external part of the cell of plants, hence, it gives plant cells their characteristic shape. The cell wall contributes to the overall flexible but rigid shape of the plant cell, protecting the cell against physical or chemical stresses.

Answer:

A horizontal row in the periodic table, which signifies the totoal number of electron shells in an element's atom.

Explanation:

Hope this helpss)):

Answer:

-1.76202

Explanation: Because the operation is subtraction, you would count the number of digits after the decimal point. Then you would perform the operation and round your answer to the SMALLER number of digits after the decimal point.

Answer:

Volume occupied is approx.  

38 ⋅ ML

Explanation:

Density  ρ = Mass  Volume  And thus  Volume  = Mass  ρ = 1.592 ⋅ l b × 454 ⋅ g ⋅ l b − 1 19.3 ⋅ g ⋅ m L − 1   =   ? ? ⋅ m L

Answer:

Both

Explanation:

if you pull a mountain a part that would be great consequences and if a volcano breaks there will be fire .

Answer:

    2H2    +   1 O2   ------>    2H2O

m = 12.7g                              m = ?

Get the number of moles for Hydrogen gas (H2) by dividing the mass by the molar mass (1.01g/mol as listed in the periodic table for its atomic mass)

12.7/1.01 = 12.57 mol of H2

Now use the mole to mole ratio of Hydrogen gas (H2) and water (H2O).

From the balanced equation, we can see that 2 mol of H2 gives us 2 mol of H2O. Since both of the ratios are equal (2:2), the moles we have for hydrogen gas is the same as the moles we get for water.

12.57 mol of H2O

Now that we have the amount of mol for H2O produced in this reaction, we can convert it to grams by multiplying the moles by the molar mass.

Molar mass of H2O = (1.01 x 2) + (16) = 18.02g/mol

12.57 x 18.02 = 226.5g (rounded)

Therefore 226.5g of water will be produced in this reaction

According to law of conservation of mass and stoichiometry, 114.3 g of water are produced if 12.7 grams of hydrogen reacted with an unknown amount of oxygen.

According to law of conservation of mass, it is evident that mass is neither created nor destroyed rather it is restored at the end of a chemical reaction .

Law of conservation of mass and energy are related as mass and energy are directly proportional which is indicated by the equation E=mc².Concept of conservation of mass is widely used in field of chemistry, fluid dynamics.

2 H₂ + O₂[tex]\rightarrow[/tex] 2 H₂O,according to this equation,4 g hydrogen reacts with 32 g oxygen to give 36 g water, thus 12.7 g of hydrogen will produce 12.7×36/4=114.3 g water and hence for this amount of water to be formed  12.7 g of hydrogen reacts with 101.6 g of oxygen which is obtained as 114.3-12.7=101.6 g

Thus, 114.3 g of water is produced.

Learn more about law of conservation of mass,here:

https://brainly.com/question/28711001

#SPJ2

Answer:

D.

Explanation:

A concentrated solution is one that has a lot of solute (the substance being dissolved) in the solvent (the substance doing the dissolving). When a solution is concentrated, it means it has a high ratio of solute to solvent, so the answer is D.

Hope this helps.

1. If the surface area of liquid is large then evaporation will be

A. small

B. large

C. moderate

D. slow

B. Large

Evaporation increases with increasing surface area. This is because the greater the surface area (exposed to the air), the more molecules escape into the air.

More surface area = Higher rate of evaporation.

Answer:

I think the answer is A physical property is a characteristic of a substance that can be observed or measured without changing the identity of the substance. Physical properties include color, density, hardness, and melting and boiling points. A chemical property describes the ability of a substance to undergo a specific chemical change.

Explanation:

I hope this helps.

Answer:

Physical change is the same substance, while a chemical change is a new substance.

Answer:

Artificial selection, also called "selective breeding” is where humans select for desirable traits in agricultural products or animals, rather than leaving the species.

Answer:

a subshell is a subdivision of electron shells that are separated by electron orbitals.

Explanation:

(subshells are labeled s,p,d, and f in an electron configuration)

The periodic table is composed of metals and nonmetals arranged in groups and periods.

The periodic table is an arrangement of elements in groups and periods based on their properties. The properties of elements repeat at regular intervals hence the term, "periodic".

The answers to the questions are;

7)  Element Families on the Periodic Table have similar properties. There are 18 families.

8) Alkali Metals are good conductors of heat and electricity.

9) There are a total of 38 elements that are grouped as Transition Metals.

10)  As opposed to metals, non-metals can be very opaque. They have no metallic luster and do not reflect light.

11)  All Lanthanide Series elements occur naturally except for promethium.

12)  All Actinide Series elements are radioactive and most are synthetic.

Learn more about the periodic table: https://brainly.com/question/24719506  

Answer:

Magnesium is Mg.

Phosphorus is P.

The two ions present in the solution are:

1. Sodium ion, Na⁺

2. Hydroxide ion, OH¯

The correct answer to the question is the 3rd option. The sodium ion is positive, and the hydroxide ion is negative.

Ions are atoms or group of atoms which possess an electric charge.

Aqueous Sodium hydroxide, NaOH contains sodium ion and hydroxide ion.

The sodium ion is positive while the hydroxide ion is negative as illustrated below:

NaOH(aq) —> Na⁺(aq) + OH¯(aq)

From the illustration above, we can conclude that the correct answer to the question is the 3rd option. The sodium ion is positive, and the hydroxide ion is negative.

Please see attached photo for further details

Learn more: https://brainly.com/question/4414335

Answer:

SO2

Explanation:

that's my answer

Sana mKatolong

Answer: photosphere.

Explanation:

The part of the Sun commonly called its surface is the photosphere. The word photosphere means "light sphere" – which is apt because this is the layer that emits the most visible light. It’s what we see from Earth with our eyes.